|
"Under hard braking at the top end,
the oil pressure would go to almost zero. After installing your MasterLube
system, our pressure never drops below 40 PSI even under the hardest
braking. Your system is definitely a bearing saver, and is essentially
a 'Dry Sump' for the racer on a budget. I also liked the fact that we
can prelube the engine before we start it." "My boat usually
sits for a week or two without being started...this has always bothered
me, as has that knocking and ticking noise in the first few seconds when
I first started it those noises were not there when the boat was
new. Since installing your 3 quart MasterLube model, the boat starts just
like new, without the noises! Thanks for a great product." "I have been looking for a product
like this for years, now I simply turn on a switch, wait a few seconds
for oil pressure to register on the gauge, then start my engine. It even
starts easier, without any of those clicking noises that it had before.
Thanks for a great product." "The MasterLube
took less than an hour to install, and setup. When I hit the switch it
worked just as just as I expected...I saw oil pressure then started my
engine, and watched the pressure gauge as the system refilled itself " "I have always believed that an ounce
of prevention is worth a pound of cure. Now, with the MasterLube system,
I am pushing 2 quarts of prevention (oil) through my boats engines before
I start them. Thanks for the great service when I had questions and for
a wonderful product." I think all engines
should come equipped with a Masterlube system. It was so easy to install.
Once installed, just push the button and it works! It even looks really
good in the engine compartment" "Your company should be complimented
on a wonderfully engineered product it works even better than expected.
I am definitely keeping this one or buying another for my next boat." "I have worked
on heavy equipment for 25 years, I have seen systems costing many thousands
of dollars, that do the same job, but are very complicated in their design.
The MasterLube system only took an hour to install. I am very happy that
I can have oil pressure before I start my boat, no matter how long it
has been sitting"
|
|
|||
| Copyright
2001, MasterLube Industries & Bantley Design Site Design by Bantley Design |
||||